CPCS A58 360 Excavator Training Northern Ireland


There are a number of activities involved with the CPCS A58 360 Excavator technical test at BSD Training Northern Ireland including;

1. Complete all manufacturers’ pre-start and running checks and prepare the excavator  for travel
2. Travel to the work area and;
a. Travel up and down the slope
b. Pass through a restriction
c. Travel over rough terrain
3. Prepare and set the excavator for the relevant work
4. Produce a vertical trench to the specified dimensions
5. Produce 2x straight trenches to form a “t” pattern with square starts and finishes
6. Load material into a vehicle
7. Change the bucket
8. Lift the load from minimum radius, position the load at 75% of full radius and rotate for a minimum of 180 degrees. On completion land the load at a given point and detach
9. Reinstate the work area back to the original state
10. Park the excavator and carry out shut-down and securing procedures

For more information about the 360 below 10tonne CPCS Test please contact us on 02892639459 or

izmir escort bayan izmir escort bayan izmir escort bayan izmir escort bayan denizli escort bayan antalya escort antalya escort Antalya escort bayan Ankara escort ankara escort izmir escort bayan izmir escort bayan